RideableCharger

Jetson Zone Charger

The Jetson Zone uses a 42V charger. The plug type has not been confirmed.

You need:

A 42V 1–2A charger

Before you buy

Match the plug on your old charger's label.

Jetson Zone

Charger

Official Jetson charger

Output
42V 1–2A
Plug
3-prong round (8–9mm)
More details
Output
42V 1–2A
Plug
3-prong round (8–9mm)
Type
External brick
Notes
PJ240V10A-ADX / MSL-CH42040P (42V)
Jetson charger guide

Jetson's official charger for this model is PJZONE-CH or PJ240V10A-ADX (charger model MSL-CH42040P). Check your charger's label for that part number.

All models that use this charger

Stock changes often, so availability may vary by store.

Check the voltage before you buy.

24V hoverboards need a 29.4V charger and 36V hoverboards need a 42V charger, and both often use the same 3-prong plug. Check the output voltage on your old charger's label before buying.

29.4V vs 42V hoverboard chargers explained
Look for the UL safety certification mark on your charger's label.

Specs

BrandJetson
TypeHoverboard
Battery voltage36V
Charger output42V 1–2A
Plug3-prong round (8–9mm) (round, 3 pins)
Match✓ Confirmed match
Common questions
Can I use a universal charger on the Zone?

A universal charger is not recommended.

How do I know my charger is bad?

Common signs: the charger light stays the same color (or never lights) when plugged into the hoverboard, the battery never reaches full, the brick gets very hot or smells burnt, or a multimeter reads no voltage (or far below the rated output) at the plug. Also check the cable and plug pins for damage.

Where can I buy a replacement charger for the Jetson Zone?

Contact Jetson's support for an original replacement.

Other Jetson models