RideableCharger

Jetson Flash Charger

The Jetson Flash uses a 29.4V charger. The plug type has not been confirmed.

You need:

A 29.4V 0.4–2A charger

Before you buy

Match the plug on your old charger's label.

Jetson Flash

Charger

Official Jetson charger

Output
29.4V 0.4–2A
Plug
3-prong round
More details
Output
29.4V 0.4–2A
Plug
3-prong round
Type
External brick
Notes
Original Jetson charger: PJ29V15A-CH-EL (29.4V 1.5A)
Jetson charger guide

Original Jetson charger: PJ29V15A-CH-EL (29.4V 1.5A).

All models that use this charger

Stock changes often, so availability may vary by store.

Check the voltage before you buy.

24V hoverboards need a 29.4V charger and 36V hoverboards need a 42V charger, and both often use the same 3-prong plug. Check the output voltage on your old charger's label before buying.

29.4V vs 42V hoverboard chargers explained
Look for the UL safety certification mark on your charger's label.

Specs

BrandJetson
TypeHoverboard
Battery voltage24V
Charger output29.4V 0.4–2A
Plug3-prong round (round, 3 pins)
Match✓ Confirmed match
Common questions
Can I use a universal charger on the Flash?

Only if it outputs 29.4V and has a 3-prong round plug.

How do I know my charger is bad?

Common signs: the charger light stays the same color (or never lights) when plugged into the hoverboard, the battery never reaches full, the brick gets very hot or smells burnt, or a multimeter reads no voltage (or far below the rated output) at the plug. Also check the cable and plug pins for damage.

Where can I buy a replacement charger for the Jetson Flash?

Contact Jetson's support for an original replacement.

Other Jetson models