Hover-1 Jive Charger
The Hover-1 Jive uses a 42V charger with a DC 5.5x2.1/2.5mm barrel (small round plug).
You need:
An official Hover-1 charger, part PTS-CHG-ES6
Before you buy
Match the voltage on your old charger's label; chargers with different voltages can share the same plug.
Charger
Official Hover-1 charger
- Part number
- PTS-CHG-ES6
More details
- Official charger output
- 42V 1.5–2A
- Type
- Brand-specific charger
- Notes
- original PTS-CHG-ES6. Third-party: 42V, 5.5x2.5mm
Stock changes often, so availability may vary by store.
Specs
| Brand | Hover-1 |
|---|---|
| Type | Electric scooter |
| Battery voltage | 36V |
| Official charger output | 42V 1.5–2A |
| Match | Check before buying |
Common questions
Can I use a universal charger on the Jive?
A universal charger is not recommended. Use the charger made for this model.
How do I know my charger is bad?
Common signs: the charger light stays the same color (or never lights) when plugged into the scooter, the battery never reaches full, the brick gets very hot or smells burnt, or a multimeter reads no voltage (or far below the rated output) at the plug. Also check the cable and plug pins for damage.
Where can I buy a replacement charger for the Hover-1 Jive?
Hover-1's official store has the charger shown on this page.