Hover-1 Rocket 2.0 Charger
The Hover-1 Rocket 2.0 uses a 42V charger with a 3-prong round (8–9mm) (round, 3 pins).
You need:
An official Hover-1 charger, part PTS-CHG-HB3
Charger
Official Hover-1 charger
- Part number
- PTS-CHG-HB3
More details
- Official charger output
- 42V 1–2A
- Type
- Brand-specific charger
Compatible alternatives (not made by Hover-1)
Questions about fit? Ask the seller before buying.
We may earn a small commission if you buy through these links, at no extra cost to you.
Stock changes often, so availability may vary by store.
Check the voltage before you buy.
24V hoverboards need a 29.4V charger and 36V hoverboards need a 42V charger, and both often use the same 3-prong plug. Check the output voltage on your old charger's label before buying.
29.4V vs 42V hoverboard chargers explainedSpecs
| Brand | Hover-1 |
|---|---|
| Type | Hoverboard |
| Battery voltage | 36V |
| Official charger output | 42V 1–2A |
| Match | ✓ Confirmed match |
Common questions
Can I use a universal charger on the Rocket 2.0?
A universal charger is not recommended. Use the charger made for this model.
How do I know my charger is bad?
Common signs: the charger light stays the same color (or never lights) when plugged into the hoverboard, the battery never reaches full, the brick gets very hot or smells burnt, or a multimeter reads no voltage (or far below the rated output) at the plug. Also check the cable and plug pins for damage.
Where can I buy a replacement charger for the Hover-1 Rocket 2.0?
Hover-1's official store or Amazon have the charger shown on this page.