Hover-1 Firefly Charger
The Hover-1 Firefly uses a 42V charger. The plug type has not been confirmed.
You need:
A 42V 1–2A charger
Before you buy
Match the plug on your old charger's label.
Charger
Official Hover-1 charger
- Output
- 42V 1–2A
- Plug
- 3-prong round (8–9mm)
More details
- Output
- 42V 1–2A
- Plug
- 3-prong round (8–9mm)
- Type
- External brick
- Notes
- 42V 3-pin
Stock changes often, so availability may vary by store.
Check the voltage before you buy.
24V hoverboards need a 29.4V charger and 36V hoverboards need a 42V charger, and both often use the same 3-prong plug. Check the output voltage on your old charger's label before buying.
29.4V vs 42V hoverboard chargers explainedSpecs
| Brand | Hover-1 |
|---|---|
| Type | Hoverboard |
| Battery voltage | 36V |
| Charger output | 42V 1–2A |
| Plug | 3-prong round (8–9mm) (round, 3 pins) |
| Match | ✓ Confirmed match |
Common questions
Can I use a universal charger on the Firefly?
A universal charger is not recommended.
How do I know my charger is bad?
Common signs: the charger light stays the same color (or never lights) when plugged into the hoverboard, the battery never reaches full, the brick gets very hot or smells burnt, or a multimeter reads no voltage (or far below the rated output) at the plug. Also check the cable and plug pins for damage.
Where can I buy a replacement charger for the Hover-1 Firefly?
Hover-1's official store has the charger shown on this page.