Swagtron T6 Charger
The Swagtron T6 uses a 42V charger with a 3-prong round (8–9mm) (round, 3 pins).
You need:
A 42V 1–2A charger with a 3-prong round (8–9mm) plug
Charger
Hoverboard charger 42V, round 3-prong
- Output
- 42V 1–2A
- Plug
- 3-prong round (8–9mm)
More details
- Output
- 42V 1–2A
- Plug
- 3-prong round (8–9mm)
- Type
- External brick
- Notes
- 42V 2A
Compatible alternatives (not made by Swagtron)
Questions about fit? Ask the seller before buying.
We may earn a small commission if you buy through these links, at no extra cost to you.
Stock changes often, so availability may vary by store.
Check the voltage before you buy.
24V hoverboards need a 29.4V charger and 36V hoverboards need a 42V charger, and both often use the same 3-prong plug. Check the output voltage on your old charger's label before buying.
29.4V vs 42V hoverboard chargers explainedSpecs
| Brand | Swagtron |
|---|---|
| Type | Hoverboard |
| Battery voltage | 36V |
| Charger output | 42V 1–2A |
| Plug | 3-prong round (8–9mm) (round, 3 pins) |
| Match | ✓ Confirmed match |
Common questions
Can I use a universal charger on the T6?
Only use one that outputs 42V 1–2A and has the 3-prong round (8–9mm) plug.
How do I know my charger is bad?
Common signs: the charger light stays the same color (or never lights) when plugged into the hoverboard, the battery never reaches full, the brick gets very hot or smells burnt, or a multimeter reads no voltage (or far below the rated output) at the plug. Also check the cable and plug pins for damage.
Where can I buy a replacement charger for the Swagtron T6?
Amazon or the other store listed above have the charger shown on this page.